Man

Command Section
UVSCOM(4)              FreeBSD Kernel Interfaces Manual              UVSCOM(4)

NAME
     uvscom - USB support for SUNTAC Slipper U VS-10U serial adapters driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device usb
           device ucom
           device uvscom

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

           uvscom_load="YES"

HARDWARE
     The uvscom driver supports the following adapters:

        DDI Pocket Air H" [email protected]
        DDI Pocket Air H" [email protected] 64
        NTT P-in
        NTT P-in [email protected]

DESCRIPTION
     The uvscom driver provides support for the SUNTAC Slipper U VS-10U chip.
     Slipper U is a PC Card to USB converter for data communication card
     adapters.

     The device is accessed through the ucom(4) driver which makes it behave
     like a tty(4).

FILES
     /dev/ttyU*       for callin ports
     /dev/ttyU*.init
     /dev/ttyU*.lock  corresponding callin initial-state and lock-state
                      devices

     /dev/cuaU*       for callout ports
     /dev/cuaU*.init
     /dev/cuaU*.lock  corresponding callout initial-state and lock-state
                      devices

SEE ALSO
     tty(4), ucom(4), usb(4)

HISTORY
     The uvscom driver first appeared in FreeBSD and later in NetBSD 1.6.
     This manual page was adopted from NetBSD by Tom Rhodes
     <[email protected]> in April 2002.

FreeBSD 11.1-RELEASE-p4         April 26, 2017         FreeBSD 11.1-RELEASE-p4
Command Section