Command Section
SEMGET(2)                 FreeBSD System Calls Manual                SEMGET(2)

     semget - obtain a semaphore id

     Standard C Library (libc, -lc)

     #include <sys/types.h>
     #include <sys/ipc.h>
     #include <sys/sem.h>

     semget(key_t key, int nsems, int flag);

     Based on the values of key and flag, semget() returns the identifier of a
     newly created or previously existing set of semaphores.  The key is
     analogous to a filename: it provides a handle that names an IPC object.
     There are three ways to specify a key:

        IPC_PRIVATE may be specified, in which case a new IPC object will be

        An integer constant may be specified.  If no IPC object corresponding
         to key is specified and the IPC_CREAT bit is set in flag, a new one
         will be created.

        The ftok(3) function may be used to generate a key from a pathname.

     The mode of a newly created IPC object is determined by OR'ing the
     following constants into the flag argument:

     SEM_R         Read access for user.

     SEM_A         Alter access for user.

     (SEM_R>>3)    Read access for group.

     (SEM_A>>3)    Alter access for group.

     (SEM_R>>6)    Read access for other.

     (SEM_A>>6)    Alter access for other.

     If a new set of semaphores is being created, nsems is used to indicate
     the number of semaphores the set should contain.  Otherwise, nsems may be
     specified as 0.

     The semget() system call returns the id of a semaphore set if successful;
     otherwise, -1 is returned and errno is set to indicate the error.

     The semget() system call will fail if:

     [EACCES]           Access permission failure.

     [EEXIST]           IPC_CREAT and IPC_EXCL were specified, and a semaphore
                        set corresponding to key already exists.

     [EINVAL]           The number of semaphores requested exceeds the system
                        imposed maximum per set.

     [EINVAL]           A semaphore set corresponding to key already exists
                        and contains fewer semaphores than nsems.

     [EINVAL]           A semaphore set corresponding to key does not exist
                        and nsems is 0 or negative.

     [ENOSPC]           Insufficiently many semaphores are available.

     [ENOSPC]           The kernel could not allocate a struct semid_ds.

     [ENOENT]           No semaphore set was found corresponding to key, and
                        IPC_CREAT was not specified.

     semctl(2), semop(2), ftok(3)

FreeBSD 11.1-RELEASE-p4        February 7, 2016        FreeBSD 11.1-RELEASE-p4
Command Section