Man

Command Section
MLX4EN(4)              FreeBSD Kernel Interfaces Manual              MLX4EN(4)

NAME
     mlx4en - Mellanox ConnectX-3 10GbE/40GbE network adapter driver

SYNOPSIS
     To compile this driver into the kernel, place these lines in your kernel
     configuration file:

           options COMPAT_LINUXKPI
           device mlx4
           device mlx4en

     To load the driver as a module at run-time, run this command as root:

           kldload mlx4en

     To load the driver as a module at boot time, place this line in
     loader.conf(5):

           mlx4en_load="YES"

DESCRIPTION
     Mellanox ConnectX adapter cards with Virtual Protocol Interconnect (VPI)
     provide the highest performing and most flexible interconnect solution
     for Enterprise Data Centers, High-Performance Computing, and Embedded
     environments.  Clustered data bases, parallelized applications,
     transactional services and high-performance embedded I/O applications
     will achieve significant performance improvements resulting in reduced
     completion time and lower cost per operation.

HARDWARE
     The mlx4en driver supports the following network adapters:

        Mellanox ConnectX-2 (ETH)
        Mellanox ConnectX-3 (ETH)

SUPPORT
     For general information and support, go to the Mellanox support website
     at: http://www.mellanox.com/.

     If an issue is identified with this driver and a supported network
     adapter, please email the specific information to
     <[email protected]>.

SEE ALSO
     mlx4ib(4), ifconfig(8)

HISTORY
     The mlx4en device driver first appeared in FreeBSD 9.x.

AUTHORS
     The mlx4en driver was written by Mellanox Technologies
     <[email protected]>.

FreeBSD 11.1-RELEASE-p4          March 1, 2017         FreeBSD 11.1-RELEASE-p4
Command Section