Command Section
IXGB(4)                FreeBSD Kernel Interfaces Manual                IXGB(4)

     ixgb - Intel(R) PRO/10GbE Ethernet driver for the FreeBSD operating

     To compile this driver into the kernel, place the following line in your
     kernel configuration file:

           device ixgb

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):


     The ixgb driver provides support for PCI Gigabit Ethernet adapters based
     on the Intel 82597EX Ethernet controller chips.  The driver supports
     Transmit/Receive checksum offload and Jumbo Frames.

     For questions related to hardware requirements, refer to the
     documentation supplied with your Intel PRO/10GbE adapter.  All hardware
     requirements listed apply to use with FreeBSD.

     Support for Jumbo Frames is provided via the interface MTU setting.
     Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility
     configures the adapter to receive and transmit Jumbo Frames.  The maximum
     MTU size for Jumbo Frames is 16114.

     This driver version supports VLANs.  For information on enabling VLANs,
     see ifconfig(8).

     The ixgb driver supports the following cards:

        Intel PRO/10GbE LR Server Adapter
        Intel PRO/10GbE SR Server Adapter

     ixgb%d: Unable to allocate bus resource: memory  A fatal initialization
     error has occurred.

     ixgb%d: Unable to allocate bus resource: interrupt  A fatal
     initialization error has occurred.

     ixgb%d: watchdog timeout -- resetting  The device has stopped responding
     to the network, or there is a problem with the network connection

     For general information and support, go to the Intel support website at:

     If an issue is identified with the released source code on the supported
     kernel with a supported adapter, email the specific information related
     to the issue to <[email protected]>.

     arp(4), em(4), netintro(4), ng_ether(4), polling(4), vlan(4), ifconfig(8)

     The ixgb device driver first appeared in FreeBSD 4.11 and FreeBSD 5.3.

     The ixgb driver was written by Intel Corporation <[email protected]>.

FreeBSD 11.1-RELEASE-p4         August 18, 2006        FreeBSD 11.1-RELEASE-p4
Command Section