Command Section
INTRO(8)                FreeBSD System Manager's Manual               INTRO(8)

     intro - introduction to system maintenance procedures and commands

     This section contains information related to system operation and

     It describes commands used to create new file systems (newfs(8)), verify
     the integrity of the file systems (fsck(8)), control disk usage
     (edquota(8)), maintain system backups (dump(8)), and recover files when
     disks die an untimely death (restore(8)).  Network related services like
     inetd(8) and ftpd(8) are also described.

     All commands set an exit status.  Its value may be tested to see if the
     command completed normally.  Unless otherwise noted (rare), the value 0
     signifies successful completion of the command, while a value >0
     indicates an error.  Some commands attempt to describe the nature of the
     failure by using error codes defined in sysexits(3), or set the status to
     arbitrary values >0 (typically 1), but many such values are not described
     in the manual.

     A number of pages in this section describe general system management

     For example, the boot(8) manual page describes the system bootstrapping
     procedures, and the diskless(8) manual page describes how to boot a
     system over a network.  The crash(8) manual page should be consulted to
     understand how to interpret system crash dumps.

     The intro section manual page appeared in 4.2BSD.

FreeBSD 11.1-RELEASE-p4        October 22, 2006        FreeBSD 11.1-RELEASE-p4
Command Section