Command Section
ICHWD(4)               FreeBSD Kernel Interfaces Manual               ICHWD(4)

     ichwd - device driver for the Intel ICH watchdog interrupt timer

     To compile this driver into the kernel, place the following line in your
     kernel configuration file:

           device ichwd

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):


     The ichwd driver provides watchdog(4) support for the watchdog interrupt
     timer present on all Intel ICH motherboard chipsets.

     The ICH WDT counts down in ticks of approximately 0.6 seconds; the exact
     value depends on hardware quality and environmental factors.  Supported
     watchdog intervals range from 2 to 63 ticks.

     Note that on some ICH-based systems, the WDT may be present but disabled,
     either in hardware or by the BIOS.  The ichwd driver attempts to detect
     this condition and will refuse to attach if it believes the WDT is

     watchdog(4), watchdog(8), watchdogd(8), watchdog(9)

     Using the Intel ICH Family Watchdog Timer (WDT), Intel Application Note
     AP-725, Document Number 292273-001.

     The ichwd driver first appeared in FreeBSD 5.3.

     The ichwd driver was written by Wm. Daryl Hawkins <[email protected]> of
     Texas A&M University and Dag-Erling Sm/rgrav <[email protected]>.  This
     manual page was written by Dag-Erling Sm/rgrav <[email protected]>.

FreeBSD 11.1-RELEASE-p4         August 20, 2008        FreeBSD 11.1-RELEASE-p4
Command Section