Command Section
CDCE(4)                FreeBSD Kernel Interfaces Manual                CDCE(4)

     cdce - USB Communication Device Class Ethernet driver

     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device uhci
           device ohci
           device usb
           device miibus
           device uether
           device cdce

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):


     The cdce driver provides support for USB Host-to-Host (aka USB-to-USB)
     and USB-to-Ethernet bridges based on the USB Communication Device Class
     (CDC) and Ethernet subclass.

     The USB bridge appears as a regular network interface on both sides,
     transporting Ethernet frames.

     For more information on configuring this device, see ifconfig(8).

     USB 1.x bridges support speeds of up to 12Mbps, and USB 2.0 speeds of up
     to 480Mbps.

     Packets are received and transmitted over separate USB bulk transfer

     The cdce driver does not support different media types or options.

     The following devices are supported by the cdce driver:

        Prolific PL-2501 Host-to-Host Bridge Controller
        Sharp Zaurus PDA
        Terayon TJ-715 DOCSIS Cable Modem

     cdce%d: no union descriptor  The driver could not fetch an interface
     descriptor from the USB device.  For a manually added USB vendor/product,
     the CDCE_NO_UNION flag can be tried to work around the missing

     cdce%d: no data interface
     cdce%d: could not read endpoint descriptor
     cdce%d: unexpected endpoint
     cdce%d: could not find data bulk in/out  For a manually added USB
     vendor/product, these errors indicate that the bridge is not compatible
     with the driver.

     cdce%d: watchdog timeout  A packet was queued for transmission and a
     transmit command was issued, however the device failed to acknowledge the
     transmission before a timeout expired.

     cdce%d: no memory for rx list -- packet dropped!  Memory allocation
     through MGETHDR or MCLGET failed, the system is running low on mbufs.

     cdce%d: abort/close rx/tx pipe failed
     cdce%d: rx/tx list init failed
     cdce%d: open rx/tx pipe failed
     cdce%d: usb error on rx/tx

     arp(4), intro(4), ipheth(4), netintro(4), urndis(4), usb(4), ifconfig(8)

     Universal Serial Bus Class Definitions for Communication Devices,

     Data sheet Prolific PL-2501 Host-to-Host Bridge/Network Controller,

     The cdce device driver first appeared in OpenBSD 3.6, NetBSD 3.0 and
     FreeBSD 6.0.

     The cdce driver was written by Craig Boston <[email protected]> based
     on the aue(4) driver written by Bill Paul <[email protected]> and
     ported to OpenBSD by Daniel Hartmeier <[email protected]>.

     Many USB devices notoriously fail to report their class and interfaces
     correctly.  Undetected products might work flawlessly when their vendor
     and product IDs are added to the driver manually.

FreeBSD 11.1-RELEASE-p4        November 24, 2015       FreeBSD 11.1-RELEASE-p4
Command Section