Command Section
AE(4)                  FreeBSD Kernel Interfaces Manual                  AE(4)

     ae - Attansic/Atheros L2 FastEthernet controller driver

     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device miibus
           device ae

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):


     The ae device driver provides support for Attansic/Atheros L2 PCIe
     FastEthernet controllers.

     The controller supports hardware Ethernet checksum processing, hardware
     VLAN tag stripping/insertion and an interrupt moderation mechanism.
     Attansic L2 also features a 64-bit multicast hash filter.

     The ae driver supports the following media types:

     autoselect       Enable autoselection of the media type and options.  The
                      user can manually override the autoselected mode by
                      adding media options to rc.conf(5).

     10baseT/UTP      Select 10Mbps operation.

     100baseTX        Set 100Mbps (FastEthernet) operation.

     The ae driver provides support for the following media options:

     full-duplex      Force full duplex operation.

     half-duplex      Force half duplex operation.

     For more information on configuring this device, see ifconfig(8).

     The ae driver supports Attansic/Atheros L2 PCIe FastEthernet controllers,
     and is known to support the following hardware:

        ASUS EeePC 701
        ASUS EeePC 900

     Other hardware may or may not work with this driver.

     Tunables can be set at the loader(8) prompt before booting the kernel or
     stored in loader.conf(5).
             This tunable disables MSI support on the Ethernet hardware.  The
             default value is 0.

     The ae driver collects a number of useful MAC counter during the work.
     The statistics is available via the sysctl(8) tree, where
     %d corresponds to the controller number.

     ae%d: watchdog timeout.  The device has stopped responding to the
     network, or there is a problem with the network connection (cable).

     ae%d: reset timeout.  The card reset operation has been timed out.

     ae%d: Generating random ethernet address.  No valid Ethernet address was
     found in the controller NVRAM and registers.  Random locally administered
     address with ASUS OUI identifier will be used instead.

     altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), vlan(4),

     The ae driver and this manual page was written by Stanislav Sedov
     <[email protected]>.  It first appeared in FreeBSD 7.1.

     The Attansic L2 FastEthernet controller supports DMA but does not use a
     descriptor based transfer mechanism via scatter-gather DMA.  Thus the
     data should be copied to/from the controller memory on each
     transmit/receive.  Furthermore, a lot of data alignment restrictions
     apply.  This may introduce a high CPU load on systems with heavy network
     activity.  Luckily enough this should not be a problem on modern hardware
     as L2 does not support speeds faster than 100Mbps.

FreeBSD 11.1-RELEASE-p4         October 4, 2008        FreeBSD 11.1-RELEASE-p4
Command Section