Command Section
AACRAID(4)             FreeBSD Kernel Interfaces Manual             AACRAID(4)

     aacraid - Adaptec AACRAID Controller driver

     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device pci
           device aacraid

           To compile in debugging code:
           options AACRAID_DEBUG=N

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):


     The aacraid driver provides support for the Adaptec by PMC RAID
     controllers, including Series 6/7/8 and upcoming families.

     The RAID containers are handled via the aacraidp0 bus.  The physical
     buses are represented by the aacraidp? devices (beginning with
     aacraidp1).  These devices enable the SCSI pass-passthrough interface and
     allows devices connected to the card such as CD-ROMs to be available via
     the CAM scsi(4) subsystem.  Note that not all cards allow this interface
     to be enabled.

     The /dev/aacraid? device nodes provide access to the management interface
     of the controller.  One node exists per installed card.  If the kernel is
     compiled with the COMPAT_LINUX option, or the aacraid_linux.ko and
     linux.ko modules are loaded, the Linux-compatible ioctl(2) interface for
     the management device will be enabled and will allow Linux-based
     management applications to control the card.

     Controllers supported by the aacraid driver include:

        Adaptec ASR-6405(T|E)
        Adaptec ASR-6445
        Adaptec ASR-6805(T|E|Q|TQ)
        Adaptec ASR-7085
        Adaptec ASR-7805(Q)
        Adaptec ASR-70165
        Adaptec ASR-71605(E|Q)
        Adaptec ASR-71685
        Adaptec ASR-72405
        Adaptec Series 8 cards

     /dev/aacraid?            aacraid management interface

     Compiling with AACRAID_DEBUG set to a number between 0 and 3 will enable
     increasingly verbose debug messages.

     The adapter can send status and alert messages asynchronously to the
     driver.  These messages are printed on the system console, and are also
     queued for retrieval by a management application.

     kld(4), linux(4), scsi(4), kldload(8)

     Achim Leubner <[email protected]>
     Ed Maste <[email protected]>
     Scott Long <[email protected]>

     The controller is not actually paused on suspend/resume.

FreeBSD 11.1-RELEASE-p4          June 19, 2015         FreeBSD 11.1-RELEASE-p4
Command Section